Power Steering Fluid Check; Brake And Clutch Fluid Check - Ford FUSION 2011 Owner's Manual

Note: Coolant expands when it is hot. The
level may therefore extend beyond the MAX
mark.
If the level is at the MIN mark, top up
immediately.
Topping up
WARNINGS
Only top up when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Do not remove the filler cap when
the engine is hot. Wait for the engine
to cool down.
Undiluted coolant is flammable and
may ignite if spilt on a hot exhaust.
CAUTIONS
In an emergency, you can add just
water to the cooling system to reach
a vehicle service station. Have the
system checked by a properly trained
technician as soon as possible.
Prolonged use of incorrect dilution of
the coolant can cause engine damage
from corrosion, overheating or
freezing.
Unscrew the cap slowly. Any pressure will
escape slowly as you unscrew the cap.
CAUTION
Do not top up further than the MAX
mark.
Top up with a 50/50 mixture of coolant
and water using fluid that meets the Ford
specification. See Technical
Specifications (page 109).
Maintenance
POWER STEERING FLUID
CHECK
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your doctor.
Make sure that the level is between
the MIN and the MAX marks.
If the level is at the MIN mark, top up
immediately.
Topping up
Remove the filler cap.
Do not top up further than the MAX
mark.
Top up with fluid that meets the Ford
specification. See Technical
Specifications (page 109).
BRAKE AND CLUTCH FLUID
CHECK
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your doctor.
If the level is at the MIN mark, have
the system checked by a properly
trained technician as soon as
possible.
108
WARNING
CAUTION
CAUTION
WARNINGS