Sony DVP-C600D Service Manual page 9

8. NOTE ON MOUNTING GEARS
1) Mount the gear (U/D). (See FIg.12.)
2) Rotate the gear (U/D) in the direction of the arrow.
(down position) (See Fig.12.)
Gear (U/D)
Fig. 12
3) Align triangle marks of the rotary encoder. (See Fig.13.)
4) Escape the set lever. (See Fig.13.)
5) Connect the boss of the gear (main) with the groove of the
rotary encoder and mount the gear (main). (See Fig.13.)
Gear (main)
Set lever
Fig. 13
6) Mount the lock lever (See Fig.14.)
7) Mount the spring (lock lever). (See Fig.14.)
Spring
(lock lever)
8) Rotate the gear (main) in the direction of the arrow A by 90°
turn. (Gear (U/D) is up position.) (See Fig.15.)
9) Mount the Gear (rev). (See Fig.15.)
10) Fix three stopper washers on the groove of shafts.
(See Fig.15.)
BU
*
Boss
Shaft
Gear (main)
Groove
Rotary encoder
Align triangle marks.
– 9 –
Lock lever
Gear
(main)
Fig. 14
Stopper washer
Groove
*
*
Two stopper
washers
A
Fig. 15
Spring
(lock lever)
Lock lever
Gear (rev)
Gear (U/D)