5. NOTE ON MOUNTING SLED MOTOR
1) Push the sled motor ass'y 1 toward direction A. (See Fig. 4)
2) Tighten two screws 2 (M1.7 × 2.5).
1 Sled motor ass'y
2 Two screws
(M1.7 × 2.5)
3) Raising the MD block ass'y 3 90 º with the side down.
confirm that the optical pick-up 4 falls by self weight.
(See Fig. 5)
4) Further, with the front side of MD block ass'y 3 up, confirm
that the optical pick-up falls by self weight.
A
Fig. 4
3 MD block ass'y
Upper
Front side
Lower
4 Optical pick-up
Lower
Fig. 5
– 6 –
Upper
Front side