Sony PXW-FS7 Quick Reference Manual page 82

I. Recording, media and troubleshooting
Unable to enable MLUTS on the HDMI output in the
Cine EI mode: The MLUT can only applied to the HDMI
output if
(MENU: Video – Output Setting – HDMI Target)
is set to Monitor.
Unable to enable MLUTS for just SDI2, HDMI or the
Viewfinder: MLUT operation is limited to ON or OFF for
all outputs and internal recording in each of the following
situations: The HDMI output is set to 4K/UHD. S&Q Motion
is enabled. Lens distortion compensation is set to AUTO
(MENU: System – Lens – Distortion Comp).
Unable to view the Waveform, Vector or Histogram
in the Cine EI Mode: Both the SDI2/HDMI output and
Viewfinder MLUT settings must be the same.
Viewfinder Information overlays are not being
displayed: Press the "Display" button on the camera body
to turn the viewfinder and monitor overlays on and off.
System Reset: If the camera is not performing as
expected try a system reset to restore the factory defaults.
Contents Section Index
82