Table of Contents
Advertisement
Setting Up a Client Computer
This section describes how to set up a client computer when you use a NetWare print server.
This section assumes that the client has NetWare client applications installed and is correctly
configured to communicate with a NetWare print server. If not, install the necessary
applications before starting the setting up procedure.
Windows 95/98
Follow these steps to set up a Windows 95/98 client.
10
11
12
NetWare Configuration
•
Log in to the NetWare file server before starting the following procedure.
1
Install the printer driver of the printer you want to use as "Local printer".
•
For more information on installing the printer driver, refer to the Operator Guide
for your printer.
•
Any port is selected during the installation, however, LPT1 is recommended.
2
Click [Start], point to [Settings], and then click [Printers].
3
In the [Printers] window, select the icon of the printer you want to use by clicking it.
4
On the [File] menu, click [Properties].
5
Click [Details] tab, and click [Add Port].
6
Click [Network] and click [Browse].
7
On the network tree, double-click the name of the computer used as the print server.
•
The names of the printers attached to the network are displayed.
8
Click the queue you want to print to highlight it, and click [OK].
9
Click [OK].
•
In the [Print to the following port] box, a network path to the printer appears.
Click [OK] to close the printer's property, and again, open it.
Click the [Printer Settings] tab.
Remove the ' marks from the [Form feed] and the [Enable banner] check boxes.
•
You should not check these boxes, since they should be specified using the
printer driver. If they are checked, the printer might not print correctly.
Setting Up a Client Computer
4 - 17
Advertisement
Table of Contents
