Table of Contents
Advertisement
Precautions
Printing after Resetting the Printer
After resetting the remote printer, the printer will be cut off from the print server for about 30-40
seconds before connecting again. Due to NetWare specification, print jobs may be accepted, but
they will not be printed during this time. When using the printer as a remote printer, wait about two
minutes after resetting the printer before attempting to print.
When Using DHCP
The following points are important when using DHCP (Dynamic Host Configuration Protocol).
Supported Systems
Windows NT Server 4.0 can be configured as a DHCP server.
Give the Printer a Static Address
Configure the DHCP server so the printer has a static address.
Follow these steps to provide the printer with a static IP address.
5
6 - 28
•
In case of Windows95/98, remove a check of [Enable banner] with [Printer Settings] tab
of property of printer.
•
When multiple DHCP servers exist, turn an equal reservation into all DHCP server. A
Network Interface Card works by information from DHCP server replied to in the first
place.
1
Start the DHCP manager.
2
Select the scope that will be used, and on the [Scope] menu, click [Reservation].
3
Enter the IP address into [IP Address].
4
Enter the MAC address of the Network Interface Card into [Unique Identifier].
•
Do not use hyphens to separate the numbers.
•
If you don't know the MAC address, it can be found on the "configuration page" printed
by the printer.
5
Enter a name and comment into the [Client Name] and [Client Comment] boxes.
6
Click [Add].
•
An IP address is reserved.
7
Click [Close], to close dialog.
Additional Functions
Advertisement
Table of Contents
