TomTom Rider 400 User Manual page 74

2. Select Search.
The search screen opens with the keyboard showing.
3. Select the type of search button to the right of the search box.
4. Select Latitude Longitude.
Tip: The example coordinates shown on the screen are your current latitude and longitude.
5. Type in your pair of coordinates. You can enter any of these coordinate types:

Decimal values, for example:
N 40.75773
40.75773, -73.985708
Tip: For decimal values you don't have to use a letter to indicate the latitude and longitude.
For locations west of the 0 meridian and locations south of the equator, use a minus sign (-)
before the coordinate.

Degrees, minutes and seconds, for example:
N 40°45'28"

GPS standard coordinates, for example:
N 40 45.46
Note: The bar below the coordinates turns red if you enter coordinates that are not recognized by
your Rider.
6. As you type in the coordinates, suggestions are shown based on what you have entered. You can
continue typing or select a suggestion.
Towns and roads are shown on the left, POIs are shown on the right.
Tip: To see more results, hide the keyboard or scroll down the results list.
Tip: You can switch between seeing the results on the map or in a list by selecting the list/map
button:
7. Select a suggestion for your destination.
The location is shown on the map.
8. To plan a route to this destination, select Drive/Ride, depending on which device you are using.
A route is planned and then guidance to your destination begins. As soon as you start driving, the
guidance view is shown automatically.
Tip: If your destination is in a different time zone, you see a plus (+) or a minus (-) sign and the
time difference in hours and half hours in the
arrival is the local time at your destination.
Tip: You can add a stop to a route
Tip: You can save a route using
W 73.985708
W 73°59'09"
W 73 59.15
that you have already planned.
My Routes.
arrival information panel. The estimated time of
74