Using Your Rider; Mounting On A Motorcycle - TomTom Rider 400 User Manual

Using your Rider

Mounting on a motorcycle

1. Attach the RAM™ mount kit to your motorcycle.
2. Fix the holder to the mount and connect the wires to your motorcycle's wiring system.
Important: The red POS (+) contact needs to be connected to the motorcycle's wiring loom at a
point between the ignition and the +12V battery supply. The black NEG (-) wire needs to be
connected to the motorcycle's wiring loom at a point between the ignition and the -(GND) battery
supply. Attach to a 12V point that can be switched off by the ignition such as the light circuit.
When you are attaching the mount kit to your motorcycle, follow these guidelines:

If you are unsure about attaching the mount kit yourself, ask a professional to fit it for you.

If you choose to attach the mount kit yourself, note that the Active Dock has a built-in fuse.
This means that you don't need to add a fuse between the device and the motorcycle battery.

Make sure that the mount kit does not interfere with any of the controls on the motorcycle.

Always use the correct tools. If you use unsuitable tools, you may damage or break the mount
kit.

Do not overtighten nuts and screws. You may crack parts of the mount kit or damage your
handlebars if you overtighten nuts or screws.
10