Table of Contents
Advertisement
To set the pump freeze protect operation, from the service
setup menu select PUMP FREEZE PROTECT. Press
MENU. Using the arrow keys, set the duration to the desired
value. To disable pump freeze protect, set the duration to
0:00. Press MENU to accept and store.
PUMP FREEZE PROTECT
2
Important Information on Freeze Protection
Freeze protection is intended to protect equipment and
plumbing for short periods of freezing only. It does this
by activating the filtration pump and circulating the water
to prevent freeze inside equipment or plumbing. Freeze
protection does not guarantee that equipment will not be
damaged by extended periods of freezing temperatures
or power outages. In these conditions, the pool and spa
should be shut down completely (e.g. drained of water and
closed for the winter) until warmer weather exists.
The pump freeze protect run time may be interrupted by
pressing a preset key, as follows:
œ
Pressing the key "
" once overrides the pump freeze protect
run time, pressing it twice turns off the pump. Pressing other
preset keys will override the pump freeze protect run time and
activate the selected preset speed.
PUMP FREEZE PROTECT
2
4.8
Selecting Pump Type
This feature is preset by factory default. At this time, the
ePump™ controller does not support other types of pumps.
1:05
3
4
ePUMP
MENU
1: FILTRATION
3
4
ePUMP
MENU
Section 5. User Set Up Options
NOTE
The ePump
TM
user interface must be in the
mode before entering the user setup mode. While in
setup mode the user interface will return back to the
OFF
mode after one (1) minute since the last key
press.
When in setup mode, preset keys "
as 'escape' or exit keys while navigating the setup menu.
To enter the setup mode, press and hold the MENU button
for five (5) seconds. The controller displays SELECT USER
SETUP. Using the arrow keys, select the desired setup item
to change.
5.1
Setting Time-of-Day
From the Setup menu, select SET TIME. Press the MENU
button to display the currently-set time. Using the arrow keys,
adjust to the desired time. Press MENU to save your setting.
SELECT USER SETUP
2
MENU
5.2
Labeling Presets
The ePump™ controller comes from the factory with pre-
programmed labels or names for the preset speeds. The labels
may be changed as desired to suit your particular installation.
Two types of labels are provided by the controller:
•
General Labels - selected from a list
•
Custom Labels - created by the user
From the setup menu, select LABEL PRESET. Press the
MENU button to display the currently selected Preset. Using
the arrow keys, choose the preset to be changed. Press MENU
to select. The controller displays SELECT LABEL TYPE.
Select GENERAL or CUSTOM as desired using the arrow
keys.
SELECT USER SETUP
LABEL PRESET
2
MENU
Page 13
OFF
œ
" through "4" are used
SET TIME
3
4
ePUMP
4
ePUMP
3
Advertisement
Table of Contents
