Cirrus SR20 Pilot Operating Handbook page 319

Cirrus Design
SR20
Holding the nozzle of a pressure washer at an angle less than
90 degrees to the graphic may lift the edges of the graphic.
4. Keep the spray nozzle perpendicular to the graphic, and at a
distance of at least 1 foot (30 cm).
5. To reduce water spotting, immediately use a silicone squeegee to
remove water.
6. Dry with a clean microfiber cloth.
Removing Difficult Contaminants
Difficult contaminants such as bugs, bird droppings, or tree sap may
require spot cleaning.
To prevent scratching the graphic, refrain from rough
scrubbing and the use of abrasive tools.
1. Soften contaminants by soaking with hot, soapy water for several
minutes.
2. Rinse thoroughly with clean water.
3. To reduce water spotting, immediately use a silicone squeegee to
remove water.
4. Dry with a clean microfiber cloth.
Initially test cleaning products on an inconspicuous area of the
graphic to verify they will not cause damage.
5. If further cleaning is needed, one of the following products may be
used: Meguiar's Gold Class™ Bug and Tar Remover, 3M™ Citrus
Base Cleaner, a mixture of two parts isopropyl alcohol to one part
water (mix ratio 2:1), or denatured alcohol.
6. Immediately rinse off all residue with clean water.
7. To reduce water spotting, immediately use a silicone squeegee to
remove water.
8. Dry with a clean microfiber cloth.
P/N 21399-004 P/N 21399-004
Revision A1
Handling, Servicing, and Maintenance
• Caution •
• Caution •
• Caution •
Section 8
8-27 8-27