Outputting The Sub Out Output From Main Out (Output Mix/Parallel); Adjusting The Brightness Of The Display (Lcd Brightness); Making The Power Automatically Turn Off After A Time (Auto Off); Saving System Settings - Roland RD-2000 Parameter Manual

Detailed Settings for Each Function
Parameter Value
Output Mix/
MIX, PARALLEL
Parallel
LCD Brightness 1–10
OFF,
30 [min],
Auto Off
240 [min]
(default)

Saving System Settings

Changes you make to the system settings are temporary, and will
be lost when you turn off the power.
If you want to keep your changes, you must save the system
settings.
1
In the SYSTEM EDIT screen, press the
button.
A confirmation message appears.
2
Press the [MENU] button.
The system settings are saved in the system memory of the RD-
2000.
If you decide to cancel, press the
Parameters saved in SYSTEM (System parameter)
5 SYSTEM
5 USB AUDIO
5 PART SW
5 COMPRESSOR

USB Audio Settings

Here you can make input/output settings for USB audio.
0 Select
[MENU] button "System"
AUDIO" tab
Parameter Value
USB Audio
OFF, ON
Input Switch
USB Audio
0–127
Input Volume
USB Audio
Output OFF, ON
Switch
26
Explanation

Outputting the SUB OUT Output from MAIN OUT (Output Mix/Parallel)

This setting specifies whether the output of zones assigned to be output from SUB OUT is sent from
MAIN OUT (Mix) or from SUB OUT (Parallel).

Adjusting the Brightness of the Display (LCD Brightness)

You can adjust the brightness of the RD-2000's display.

Making the Power Automatically Turn Off After a Time (Auto Off)

With the factory settings, the RD-2000 will automatically be switched off 4 hours after you stop playing
or operating the unit.
If you don't need the unit to turn off automatically, set
* When turning the unit back on after it has been shut down due to the Auto Off function, always make
sure to allow at least ten seconds to pass after the unit has been shut off before you turn the unit back
on. If you turn it back on too rapidly, the Auto Off function will not have had enough time to reset
itself, and you may not be able to turn on the unit in the normal way.
[WRITE]
[EXIT] button.
0 0
[ENTER] button "USB
Explanation
Specifies whether to enable
USB-AUDIO from an external
device.
Specifies the USB audio signal
level from an external device.
Specifies whether USB audio is
output to an external device.
"Auto Off" to the
Parameter Value
USB Audio
Output 0–127
Volume
USB Audio
Output MAIN, SUB
Assign
USB Audio In/
IN, OUT
Out Select
"OFF" setting.
Explanation
Specifies the USB audio signal
level to an external device.
Specifies whether the USB
audio signal is output from the
MAIN jacks or from the SUB
jacks.
Selects the USB audio signal
that is indicated and adjusted
by the slider.