Block Diagram; Dvd Mechanism Section - Clarion VRX928RVD Service Manual

NOTES OF ISO CONNECTOR
1. For VW and Audi vehicles,change the position of fuse
installation as shown on the diagram.(Figure 1)
Initial setting of extension lead
RED
BLU/WHT
15A
FUSE
For models 1992 and later
YEL
YEL
YEL
RED
RED
2. When the car stereo is installed in 1998 and later
Volkswagen models,make sure to cut the car lead wire
connected the A-5 terminal.(a breakdown could occur if
the lead wire is not cut.)After cutting the lead wire,insulate

BLOCK DIAGRAM

DVD mechanism section

VRX928RVD
YEL
For models up to 1991
YEL
YEL
RED
Figure 1
the front end of the lead wire with insulation tape to pre-
vent the risk of short-circuits.(Figure 2)
Note: Before cutting the lead wire,disconnect the car
battery - (negative)cable.
3. When Main unit is also connected to an external
amplifier,connect REMOTE on the external amplifier to
the previously cut lead wire on the side of the connector
4. When an extension lead is required in the extension cable
type wiring procedure,disconnect the auto antenna
leads(BLU/WHT).Be sure to insulate both the ISO con-
nector side terminal and the main unit side terminal with
insulation tape,respectively.(Figure 3)
RED
- 4 -
Figure 2
BLU/WHT BLU/WHT
Insulation tape
BLU/WHT
Insulate the terminal
Never let the terminals make contact
*
with the metal plate parts of the car.
Figure 3