Sharp AL-1611 Service Manual page 17

5) Gently pull the TD cartridge out while holding the handle.
6) Hold the strap on the cartridge and remove the TD cartridge
upward.
7) Remove the new TD cartridge from the bag. Hold the cartridge on
both sides and shake it horizontally four or five times.
4 or 5 times
8) Remove the protective cover from the TD cartridge by unlatching
three cover hooks from the holes on the cartridge and then pulling
the cover in the direction indicated by the arrow in the illustration.
TD cartridge lock
release lever
AL-1611/AL-1622 UNPACKING AND INSTALLATION
9) Gently insert the TD cartridge along the guides until it locks in place.
• If dirt or dust is adhered to the TD cartridge, remove it before install-
ing the cartridge.
10) Close the front cover by holding both sides with your hands and
then close the side cover. The TD cartridge replacement required
indicator will go out and the START key indicator will light up.
• When closing the covers, be sure to close the front cover securely
and then close the side cover. If the covers are closed in the wrong
order, the covers may be damaged.
11) Raise the handle of the paper tray and pull the paper tray out until it
stops.
12) Remove the pressure plate lock. Rotate the pressure plate lock in
the direction of the arrow to remove it while pressing down the pres-
sure plate of the paper tray.
5 – 2