Connect The Device With The Mobile Phone - Skoda Bolero Owner's Manual

Select ring tone - Selects the ring tone if the connected phone does not sup-
■
port the in-band ringing function
Show pictures for contacts - Switch on/off the display of the image assigned
■
to the contact in the telephone

Connect the device with the mobile phone


Introduction
This chapter contains information on the following subjects:
Conditions for pairing
Connect device with your mobile phone
Pair the mobile phone with the device
Connection with another paired mobile phone
®
Switching on / off Bluetooth profile
Clear mobile phone from the list of paired devices
Disconnection
First and foremost, pay attention to the safety instructions
tant notes.
The device is displayed in the telephone to be connected to as SKODA BT ...
... is replaced with the last four symbols of the VIN vehicle identification num-
ber of your vehicle.
You can change the name of the device
WARNING
The unit may require confirmation of certain features in the mobile phone
when pairing. Do not carry out the pairing process while driving - there is
danger of accidents!
Note
The maximum number of paired phones is 20. When the maximum number of
■
paired telephones has been reached, the next one will cause the paired tele-
phone that has not been used for the longest to be automatically deleted.
In some countries, the use of the Bluetooth
■
restricted. Further information can be obtained from local authorities.
1) The in-band ringing function makes it possible to use the ring tone of your phone as the ring tone.
2)
This function is only supported by some phones.
34
Communication
1)
2)
» page
» page 18.
®
function with phones can be
The range of the Bluetooth
■
This depends on local conditions and interference with other devices.
When pairing from the mobile phone, follow the instructions in the owner's
■
manual of the mobile phone.
Conditions for pairing

Read and observe
To connect a phone with the device, the two devices must be paired.
Prerequisites for successful pairing:
34
34 The ignition is switched on.

35 The Bluetooth

switched on.
36
36 The visibility of the mobile phone is switched on

36 The visibility of the mobile phone is switched on.

37
The mobile phone to be connected should not have an active connection

to another mobile phone.
4, Impor-
The pairing can be initiated from the device as well as from the mobile phone.
Connect device with your mobile phone

Read and observe
A telephone is paired with the device
After switching on the ignition the device attempts to connect to the last con-
nected mobile phone.
During the connection process and depending on the phone type the mes-
sage ... may be shown on the device screen Would you like to connect? and a
menu will appear with the following function keys.
›
Connect - pairing confirmation
›
Cancel - end the pairing process
If the connection cannot be established, the device will then attempt to con-
nect to other previously paired phones one by one.
If there is also no connection possible, then a phone search is to be started.
®
connection is restricted to the vehicle interior.
on page 34 first.
®
function of the device » page 18
on page 34 first.
for the mobile phone is
» page 18.
