Voice Control - Skoda Bolero Owner's Manual

Symbol
A phone is connected to the device

Missed calls (if there are several missed calls, the number

of calls is shown next to the symbol)
a) This function is only supported by some mobile phones.
Call list
In the MAXI DOT display, only the call list can be displayed and used.
If the call list includes no entries, the following message appears in the MAXI
DOT display No entries available.
The following symbols are displayed next to each entry in the call list.
Symbol
Incoming call

Outgoing call

Missed call


voice control


Introduction
This chapter contains information on the following subjects:
function requirements
Switching on/off
Help for voice control
Operation
not recognizing a voice command
override a voice command input
stop/restore voice command input
Voice commands not included in the Help
First and foremost, pay attention to the safety instructions
tant notes.
Some equipment functions can be operated using voice commands. Thus, the
use of the device is accelerated and increased comfort while driving.
Voice control can be used in the menus radio, media and phone.
12
Device operation
Meaning
Meaning
» page 4, Impor-
The voice control system can be operated either by the driver or by the front
passenger.
WARNING
Please pay attention to the traffic first and foremost! As the driver you
■
are fully responsible for road safety. Only use the system so that you are in
full control of your vehicle in every traffic situation - risk of accident!
Do not use the voice control system when under stress or in an emergen-
■
cy. Your Voice commands may not be recognized in such situations. In such
circumstances a telephone connection may not be established or the con-
nection may take too long to complete. The emergency number should be
dialled manually!
function requirements

Read and observe on page 12 first.
Function requirements for voice control.
The ignition is switched on.

The device is switched on.

No phone call is in progress.

The parking aid is not active.

Requirements for optimum voice command recognition.
›
Only issue voice commands when the symbol is displayed on the device
12
screen or appears in the information display.  .
13
›
Speak with a normal tone of voice without intonation and excessive pauses.
13 ›
Avoid a bad pronunciation.
›
13
Close doors, windows and the sliding roof, in order to prevent external dis-
14
turbances affecting recognition of the voice commands.
›
14 It is recommended to speak louder at higher speeds, so that the tone of your
voice is louder than the increased surrounding noise.
14
›
During voice control, limit additional noise in the vehicle, e.g. passengers
14
talking at the same time.
CAUTION
For some languages, there is no voice control available. The device indicates
this fact via a text message that is displayed after setting the device language
screen » page 15 .
