Aptc Detection Position Adjustment - Epson DFX-9000 Repair Manual

Epson DFX-9000 Field Repair Guide

APTC Detection Position Adjustment

Note: Before performing this adjustment, the TOF Sensor Sensitivity Adjustment and the Parallelism
Adjustment must be performed.
This adjustment is required if you:
• Replace the Printer Mechanism
• Remove or replace the Carrier Unit
• Replace the ROM Board (only when the EEPROM Data Copy failed)
1. Turn the printer on.
2. If the front paper path is not selected (indicated by a red LED on the Control Panel's Paper Path Indicator, see
the figure below), depress the
the Control Panel's Paper Path Indicator is lit.
3. Mount one (1) sheet of 18# or 20# pinfeed paper onto the front set of tractors.
4. Load the paper by depressing the
5. Run the DFX-9000 Adjustment Program.
6. Select "DFX-9000" as the "Model Name".
7. Select "EAI" as the "Destination".
Adjustments
Front/Rear button on the Control Panel one (1) time. Verify that the red LED on
LF/FF Load button on the Control Panel one (1) time.
Printer Component, Software Item, LCD Display, Printer Button
3/29/07
Page 192.