Changing The Interior Light Bulb; Changing The Opening Direction Of The Doors - Whirlpool ADN221/2 Instruction Manual

Remember that when cleaning the appliance you must disconnect the appliance
from the electrical energy supply socket by pulling the plug out of the electricity
outlet.
• Protect the appliance inner surfaces and plastic parts from fats, acids and sauces. In case of
accidental spills – immediately clean with warm soapy water or dishwashing detergent. Wipe
dry.
• Regularly clean the hermetic gaskets of the doors. Wipe dry.
• REGULARLY CLEAN THE THAW WATER CHANNEL SPACE WITH A SPECIAL CLEANER 7 FOR
THAT PURPOSE (Fig. 1).
• At least once a year clean dust away from the back part of the appliance body and the
compressor. A soft brush, electrostatic cloth or vacuum cleaner may be used for cleaning.
• DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for cleaning the
appliance inner and outer surfaces. DO NOT use for cleaning cloths or sponges that have coarse
surfaces intended for scrubbing. Outer of the doors – glass – clean with agents intended for
glass cleaning.
• IF THE APPLIANCE IS TO BE LEFT SWITCHED OFF FOR AN EXTENDED PERIOD, LEAVE ITS
DOORS OPEN.
CHANGE OF THE LAMP OF THE PROMOTIONAL SHIELD
Model ADN221 C (See page 1, fig. 3)
WARNING! Turn off the appliance and pull the plug out of the electricity supply socket.
Unscrew four screws 1. Remove the cover 2. Take out the lamp 3 from lamp fixing holders 4.
Remove lamp holders from the lamp ends. Change the lamp. Assemble everything in reverse
order. REMARK. During putting the cover, the cable fixing bushing 6 must be inserted into the
hole 7 of the cover.

CHANGING THE INTERIOR LIGHT BULB

See page 2, fig. 4
1 screws
WARNING! Turn off the appliance and pull the plug out of the electricity supply socket.
• Unscrew the screw 1 and unlink the back wall of the cover 2 from the metal bracket 3 along all
cover length in the direction D (fig. a).
• Starting from the cover bottom and pushing the cover wall from inside in the direction E, turn
the cover acc. to the arrow F and thus unlink the front cover part (fig. b).
• Remove the cover, turn the lamp by 90
• After changing the lamp, insert the cover as it is shown in fig. c, pushing it to the direction G up
to the support and then, turning the cover to the direction H, hang its back wall on the bracket
along all cover length and then screw it.

CHANGING THE OPENING DIRECTION OF THE DOORS

It is recommended that changing the opening direction of the doors should be done with a helper.
You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the appliance horizontally.
Do the actions below in the order they are listed (see page 3, fig. 5):
WARNING! Turn off the appliance and pull the plug out of the electricity supply socket.
1. In the back part unscrew four screws 21, remove the cover 22 and disconnect the supply plug
23 of the connection cable;
2. Unscrew four fixing screws 3 of the promotional shield and remove the promotional shield;
2 cover
0
clockwise and remove the lamp 4.
3 bracket
10
4 luminescent lamp