Table of Contents
Advertisement
15.9 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (9) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.
WARNING!
Make sure that the temperature is more than 5 °C and the water is flowing
from the tap before you use the appliance again.
The manufacturer is not responsible for damages caused by low
temperatures.
16. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
16.1 Introduction
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the Authorised
Service Centre.
CAUTION!
Deactivate the appliance before you do the checks.
With some problems, the acoustic signals operate and the display shows an alarm
message.
16.2 Possible failures
Problems with alarm messages
Message
The display tells to check
the tap: the appliance
does not fill with water.
15.10 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
Possible solution
Make sure that the water tap is open.
ENGLISH
41
Advertisement
Table of Contents
