Assembly - MasterForce 241-0805 Operator's Manual

CONTENTS
Sander, sanding discs (5pcs), dust box, soft
bag and operator's manual
Remove the random orbit sander from the
carton and examine it carefully. Do not
discard the carton or any packaging
material until all parts have been examined.
If any part of the sander is missing or
damaged, do not plug the sander in until
the damaged part is repaired or replaced.
WARNING:
ALWAYS turn the switch to the OFF
position and disconnect the random orbit
sander from the power outlet before
installing or changing the abrasive discs
or dust bag attachment.
INSTALLING AND REMOVING
THE ABRASIVE DISC (FIG. 1)
FIG. 1
To install:
1. Remove all sanding dust or dirt from
the sanding pad.
2. Align the holes on the abrasive disc
with the holes in the sanding pad,
making sure it is centered and that the
edges are aligned with the edges of
the sanding pad.

ASSEMBLY

To avoid injury,
NOTICE: The holes in the abrasive disc
must line up with the holes in the sanding
pad in order for the dust collection system
to function properly.
3. Press the abrasive disc to the pad.
To remove:
1. Peel the disc off the sanding pad.
INSTALLING AND REMOVING
THE DUST BOX (FIG. 2)
FIG. 2
To attach the dust box (Fig. 2):
1. Unplug the sander.
2. Align the raised rib on the dust box with
the grooves of the sander, and then
attach the dust box to the sander.
NOTICE: Make sure that the dust box
is secured to the tool before beginning
operation.
To detach the dust box:
1. Unplug the sander.
2. Pull up on the dust box and remove it
from the tool.
NOTICE: When placing the dust box on
the tool, be sure that the raised rib on the
dust box aligns with the groove on the
sander and that the dust box snaps into
place properly. Improper attachment of
the dust box can cause damage to
internal components.
Page 8