Keeping Fit With Your Swim Spa; Jetstream Propulsion System; Assembling The Swim Tether; Using The Exercise Equipment - Cal Spas PATIO Owner's Manual

52

Keeping Fit With Your Swim Spa

Jetstream Propulsion System

Use the control panel to start and stop the Jetstream Propulsion
System. The JETS 1 and JETS 2 buttons control the top and
bottom jets.
Use the air venturi valves to inject air in the water streams.

Assembling the Swim Tether

The swim tether pole has three pieces and assembles
easily. Slide the ends of the top and middle sections
into the middle and bottom sections as shown at right.
Insert the tether in the anchor hole when you are
ready to use it.
Buckle the strap around your waist. It is easily
adjustable and can accommodate most sizes.

Using the Exercise Equipment

IMPORTANT: Always consult your physician before starting any exercise activity or program. The Ultimate
Fitness series spas feature rubber exercise bands. When stretched, these bands create a high tension condition.
Improper use or failure to connect the exercise bands properly may cause injury. Always inspect all of the
exercise equipment prior to beginning any exercise. Do not use any damaged equipment.
This equipment attaches to the exercise anchors located on the spa walls.
Connecting the Exercise Equipment
The drawings below show different ways the exercise kit can be connected depending on the exercises you
wish to do.
For 14 foot spas and model F1222
The exercise kit contains:
• Two hand grips
• Two ankle braces
• Two 6" elastic bands
• Two 18" elastic bands
• Two 25" elastic bands
• Two rowing bars
www.calspas.com
For 16 and 17 foot spas
The exercise kit contains:
• Two hand grips
• Two ankle braces
• Two 18" elastic bands
• Two 25" elastic bands
• Two 56" elastic bands
• Two rowing bars
2017 Portable Spa
LTR20171001, Rev. B