Philips AquaTrio FC7070 User Manual page 28

Problem
The appliance
does not take
up water when
I flush the
mopping nozzle.
The tank full/
tank empty light
starts flashing
and the appliance
switches off
while flushing the
mopping nozzle.
The tank full/tank
empty light lights
up continuously
and the appliance
switches off
while flushing the
mopping nozzle.
I cannot move
the appliance
forwards or
backwards.
I cannot find the
vacuum cleaning
function.
D Note:
If the above solutions did not solve your problem, please visit www.philips.com/support
or contact the Philips Consumer Care Centre in your country.
28
Possible cause
You poured too much
water into the flushing
tray or you poured
it in too fast. This
causes the mopping
brushes to become
too wet. When the
brushes are too wet,
the active protection
system is activated.
The mopping
brushes stopped
rotating because they
encountered too
heavy resistance.
The clean water tank
is empty.
The dirty water tank
is full.
One or more wheels
may be blocked by a
small object.
There is no separate
vacuum cleaning
function.
Solution
Switch off the appliance, put the appliance upright in
parking position ('click'), and pull the plug out of the
wall socket. Remove the mopping brushes from the
mopping nozzle and remove excess water from the
mopping brushes by squeezing them over a sink (see
chapter 'Cleaning and maintenance', section 'Cleaning the
mopping nozzle'). Then you can reinsert the mopping
brushes, reinsert the mopping brush cover, close the
mopping nozzle lid and switch on the appliance again
(see chapter 'Cleaning and maintenance', section
'Reassembling the mopping nozzle'). If this does not
work, let the mopping brushes dry (see chapter 'Cleaning
and maintenance', section 'Cleaning the mopping nozzle').
Refill the clean water tank (see chapter 'Preparing for
use', section 'Filling the clean water tank') and start the
flushing procedure again (see chapter 'Cleaning and
maintenance', section 'Flushing your AquaTrio').
Empty the dirty water tank (see chapter 'Using your
AquaTrio', section 'Emptying the dirty water tank') and
start the flushing procedure again (see chapter 'Cleaning
and maintenance', section 'Flushing your AquaTrio').
Switch off and unplug the appliance and then put it on
its side. Make sure the dirty water tank is empty when
you put the appliance on its side, otherwise wastewater
may leak out of the dirty water tank. Check what is
blocking the wheel(s). Remove any object that could
block the wheel(s). Put the appliance upright again and
resume cleaning.
When you switch on the appliance, the mopping and the
vacuum cleaning functions work at the same time.