Table of Contents
Advertisement
Display Setup
1
Set the A-B-C Switch
Locate the A-B-C switch inside
the battery compartment. It can
be set to A, B or C. However,
you must select the same
letter choices for the display,
rain gauge and lightning
sensor in order for the units to
synchronize.
2
Install or Replace Backup
Batteries
(optional)
1. Remove the battery
compartment cover.
1
A-B-C Switch
Set to match
rain gauge
and lightning
sensor.
A B C
3
Plug in
Power
Adapter
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment that will not be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
2. Insert 3 x AA alkaline
batteries into the battery
compartment, as shown.
Follow the polarity
(+/-) diagram in the
battery compartment.
3. Replace the battery cover.
3
Plug in Power Adapter
For the best performance, plug
in the power adapter as the main
power source for this product.
IMPORTANT: Batteries
are a backup power
source to preserve records
in the event of a power
outage. Power adapter
is recommended as the
primary power source to
enjoy the full functionality
of this product.
2
10
Install Backup Batteries
(optional)
3 AA batteries
Hide quick links:
Advertisement
Table of Contents
