ABB COM600 series 5.0 Technical Reference Manual page 4
Slave protocols ethernet and applications
Hide thumbs
Also See for COM600 series 5.0:
- Technical reference manual (164 pages) ,
- Cyber security deployment manualline (52 pages)
Table of Contents
Advertisement
4
COM600 series 5.0
Slave Protocols (Ethernet) and Applications Technical
Reference Manual
4.2.11.
WYE .............................................................................. 29
4.2.12.
Delta (DEL) ................................................................... 30
4.2.13.
Controllable single point (SPC) ..................................... 30
4.2.14.
Controllable double point (DPC) ................................... 30
4.2.15.
Controllable integer status (INC) ................................... 31
4.2.16.
Controllable Enumerated Status (ENC) ........................ 31
4.2.17.
4.2.18.
Integer controlled step position information (ISC) ......... 32
4.2.19.
Analogue set point (APC) ............................................. 32
4.3.
Status codes ................................................................................ 33
4.3.1.
Introduction ................................................................... 33
4.3.2.
Link layer status codes ................................................. 33
4.3.3.
Application layer status codes ...................................... 33
4.4.
Attributes ...................................................................................... 34
4.4.1.
General information about attributes ............................ 34
4.4.2.
Client attributes ............................................................. 35
4.4.3.
Channel attributes ......................................................... 35
4.4.4.
Device attributes ........................................................... 36
5.
DNP3 LAN/WAN OPC slave ................................................................. 38
5.1.
About this section ......................................................................... 38
5.2.
IEC 61850 data modeling ............................................................ 38
5.2.1.
5.2.2.
Single point status (SPS) .............................................. 38
5.2.3.
Double point status (DPS) ............................................ 39
5.2.4.
Integer controlled step position information (ISC) ......... 45
5.2.5.
Enumerated Status (ENS) ............................................ 39
5.2.6.
Protection activation information (ACT) ........................ 40
5.2.7.
5.2.8.
Binary counter reading (BCR) ....................................... 41
5.2.9.
Measured value (MV) .................................................... 41
5.2.10.
Complex measured value (CMV) .................................. 41
5.2.11.
WYE .............................................................................. 41
5.2.12.
Delta (DEL) ................................................................... 42
5.2.13.
Controllable single point (SPC) ..................................... 43
5.2.14.
Controllable double point (DPC) ................................... 43
5.2.15.
Controllable integer status (INC) ................................... 44
5.2.16.
Controllable Enumerated Status (ENC) ........................ 44
5.2.17.
5.2.18.
Integer controlled step position information (ISC) ......... 45
5.2.19.
Analogue set point (APC) ............................................. 45
5.3.
Status codes ................................................................................ 45
5.3.1.
Introduction ................................................................... 45
5.3.2.
Link layer status codes ................................................. 45
5.3.3.
Application layer status codes ...................................... 46
5.4.
Attributes ...................................................................................... 47
5.4.1.
General information about attributes ............................ 47
1MRS758692
Advertisement
Table of Contents
