Table of Contents
Advertisement
Net 1Card IB
2/15/00 12:17 PM
C
OMMERCIAL
O
nce the Net1Card is installed and the TV plugged
back in, you can perform Net1Card setup opera-
tions for the TV. You should start with the "COMMER-
CIAL SETTINGS" menu.
BEGIN
To begin setup, press the POWER button to turn
the TV on. Then press the TV/GUEST button.
Press the A button on the remote control. The
"COMMERCIAL SETTINGS" menu appears. (The
menu stays up for approximately 2 minutes.) "MODE"
is highlighted. Press the – ( ) or + ( ) button to select
"COMMERCIAL," or "CONSUMER." Selecting
"CONSUMER" allows you access to the TV's "SETUP
MENU" with a standard remote or from the front panel
on the TV. (See page 32 for details.) "COMMERCIAL"
is the default setting. In the Commercial mode, the TV's
menu can only be accessed with a Setup remote control.
When finished, press the
"CONTROL MODE."
COMMERCIAL SETTINGS
MODE
CONTROL MODE
FRONT KEYPAD
COMMERCIAL SETTINGS
CABLE
EXIT MENU
MODE
CONTROL MODE
PRESS +/– TO CHANGE
FRONT KEYPAD
CABLE
EXIT MENU
PRESS +/– TO CHANGE
Page 18
S
ETTINGS
button to highlight
COMMERCIAL
RECEIVE
ON
YES
CONSUMER
RECEIVE
ON
YES
18
C
S
OMMERCIAL
C
ONTROL MODE allows you to setup each TV as a
"TRANSMITTER," "RECEIVER," or "FACTO-
RY."Since almost all the TV's in the Net1Card network
will be receivers, the default mode is "RECEIVER."
BEGIN
If not already in the "COMMERCIAL SET-
TINGS" menu, press the A button on the remote con-
trol. Then press the
button to highlight "CONTROL
MODE."
Press the – ( ) or + ( ) button to select "TRANS-
MITTER," "RECEIVER," or "FACTORY." Select
"TRANSMITTER" if the TV will be sending informa-
tion to the other TVs in the Net1Card network. Select
"RECEIVER" if the TV will be receiving information
sent by the Transmitter TV. Select "FACTORY" if you
want to send a signal to an individual TV to test if it is
correctly hooked up to the system. (More on these
modes later.)
When finished, press the
"FRONT KEYPAD."
COMMERCIAL SETTINGS
MODE
COMMERCIAL
CONTROL MODE
RECEIVE
FRONT KEYPAD
CABLE
COMMERCIAL SETTINGS
EXIT MENU
MODE
COMMERCIAL
PRESS +/– TO CHANGE
CONTROL MODE
FRONT KEYPAD
CABLE
COMMERCIAL SETTINGS
EXIT MENU
MODE
PRESS +/– TO CHANGE
CONTROL MODE
FRONT KEYPAD
CABLE
EXIT MENU
PRESS +/– TO CHANGE
19
ETTINGS
button to highlight
ON
YES
TRANSMIT
ON
YES
COMMERCIAL
FACTORY
ON
YES
Advertisement
Table of Contents
