ASROCK Vig103M Manual page 50

To clear the administrator password, follow the same steps as in changing an administrator password, but
press <Enter> when prompted to create/confirm the password. After you clear the password, the
Administrator Password item on top of the screen shows Not Installed.
User Password
If you have set a user password, you must enter the user password for accessing the system. The User
Password item on top of the screen shows the default Not Installed. After you set a password, this item
shows Installed.
To set a user password:
1. Select the User Password item and press <Enter>.
2. From the Create New Password box, key in a password, then press <Enter>.
3. Confirm the password when prompted.
To change a user password:
1. Select the User Password item and press <Enter>.
2. From the Enter Current Password box, key in the current password, then press <Enter>.
3. From the Create New Password box, key in a new password, then press <Enter>.
4. Confirm the password when prompted.
To clear the user password, follow the same steps as in changing a user password, but press<Enter>
when prompted to create/confirm the password. After you clear the password, the User Password item on
top of the screen shows Not Installed.
4.9.1 Chassis Intrusion Configuration
Chassis Intrusion
This item allows you to enable or disable messages when chassis is opened.
Configuration options: [Enabled] [Disabled]
V1.0 Vig103M Motherboard Manual
49