Wiring Diagrams; Warranty; Replacement Parts; Product Reference Information - Lennox ED4540CNM-2 Homeowner's Care And Operation Instructions Manual

45" direct-vent elite series gas fireplace heaters
Table of Contents

Advertisement

WIRING DIAGRAMS

Wiring diagrams are provided here for refer-
ence purposes only. This information is also
provided on schematics attached directly to
the appliance on a pullout panel located within
the control compartment.
CAUTION: LABEL ALL WIRES PRIOR TO DIS-
CONNECTION WHEN SERVICING CONTROLS.
WIRING ERRORS CAN CAUSE IMPROPER AND
DANGEROUS APPLIANCE OPERATION.
Millivolt Wiring Diagram
If any of the original wire as supplied must be replaced, it
must be replaced with Type AWM 200°C – 18 GA. wire.
Thermopile
APPLIANCE-MOUNTED ON/OFF SWITCH
*OPTIONAL WALL-MOUNTED ON/OFF
SWITCH OR OPTIONAL THERMOSTAT
*Turn the appliance-mounted ON/OFF burner control switch to
the OFF position if an optional control switch is installed.
Schematic Representation Only

WARRANTY

Your gas appliance is covered by a limited
twenty year warranty. You will find a copy of
the warranty accompanying this manual. Please
read the warranty to be familiar with its cover-
age.
Retain this manual. File it with your other docu-
ments for future reference.

PRODUCT REFERENCE INFORMATION

We recommend that you record the following important information about your fireplace. Please
contact your Lennox dealer for any questions or concerns. For the number of your nearest Lennox
dealer, please call 800-731-8101
Your Fireplace's Model Number _______________________________________
Your Fireplace's Serial Number ________________________________________
The Date On Which Your Fireplace Was Installed __________________________
The Type of Gas Your Fireplace Uses ___________________________________
Your Dealer's Name _________________________________________________
8
Electronic Wiring Diagram (Honeywell)
Showing the Blower Wiring for the Optional
FBK-100 and FBK-200 Kits
1. If any of the original wire as supplied must be replaced,
1.
it must be replaced with Type AWM 200°C – 18 GA.
wire.
2. 120V, 60Hz – Less than 3 amps.
**ON/OFF Switch (Integral
with Gas Valve)
Gas Valve
BK
R
BL
OPT
BLOWER
Hot side of Outlet
BK
Field Wired
Factory Wired
*Blower speed control switch is provided in FBK200 blower kit.
***Turn the appliance-mounted ON/OFF burner control switch
to the OFF position if an optional control switch is installed.
Factory Wired

REPLACEMENT PARTS

A complete parts list is found at the end of this
manual. Use only parts supplied from the
manufacturer.
Normally, all parts should be ordered through
your Superior distributor or dealer. Parts will be
shipped at prevailing prices at time of order.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
**Leave the ON/OFF switch, which is integral
with the gas valve, in the ON position.
*OPTIONAL
ACCESSORY
SWITCH
PILOT
ASSEMBLY
BK
120
W
J-box Green
VAC.
G
Ground
Screw
Outlet Box
Green Ground
G
Screw
Black
pigtail
Break Off
Tab
Red
pigtail
White Wire
to Opposite
Side
Junction Box
W
B
Transf.
120 V.
24 V
BL
R
R
R
***OPTIONAL WALL SWITCH
OR OPTIONAL THERMOSTAT
APPLIANCE-MOUNTED ON/OFF SWITCH
Field Wired
Schematic Representation Only
Electronic Wiring Diagram (Honeywell)
Showing the Blower Wiring for the Optional
FBK-250 Kits
1. If any of the original wire as supplied must be replaced,
1.
it must be replaced with Type AWM 200°C – 18 GA.
wire.
2. 120V, 60Hz – Less than 3 amps.
*Leave the ON/OFF switch, which is integral
with the gas valve, in the ON position.
*ON/OFF Switch (Integral
with Gas Valve)
Outlet Box Green
Ground Screw
Gas Valve
PILOT
ASSEMBLY
BK
Optional FBK-250
R
Module
BL
OPT
BLOWER
W
B
Hot side of Outlet
BL
R
BK
**OPTIONAL WALL SWITCH
OR OPTIONAL THERMOSTAT
APPLIANCE-MOUNTED ON/OFF SWITCH
**Turn the appliance-mounted ON/OFF burner control switch to
the OFF position if an optional control switch is installed.
Factory Wired
Schematic Representation Only
When ordering repair parts, always give the
following information:
1. The model number of the appliance.
2. The serial number of the appliance.
3. The part number.
4. The description of the part.
5. The quantity required.
6. The installation date of the appliance.
If you encounter any problems or have any
questions concerning the installation or appli-
cation of this system, please contact your dis-
tributor, or Superior directly:
LENNOX HEARTH PRODUCTS
4325 Artesia Avenue
Fullerton, CA 92833
(714) 521-7302
G
120
BK
VAC.
W
White Wire
To Opposite
Side
J-box Green
Ground Screw
Junction Box
G
Transf.
120 V.
24 V
R
R
Field Wired

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ed4540cpm-2Ed4540cpe-2Ed4540cne-2

Table of Contents