Table of Contents
Advertisement
RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAM-
AGE, PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY: Do not store or use gasoline
or other flammable vapors or liquids in the vicin-
ity of this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone.
Follow your gas suppliers instructions.
• If your gas supplier cannot be reached, call the
fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
WH Report No. J20006701
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
DIRECT VENT
ELITE
45" DIRECT-VENT GAS FIREPLACE HEATERS
P/N 504,135M REV. A 04/2001
MODELS
M
l i
v i l
t l o
M
o
e d
s l
E
D
5 4
0 4
C
N
M
E
D
5 4
0 4
C
P
M
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE
LES INSTRUCTIONS DONNÉ DANS CETTE NOTICE POUR
RÉDUIRE AU MINIMUM LE RISQUE D'INCENDIE OU
POUR ÉVITER TOUT DOMMAGE MATÉRIEL, TOUTE
BLESSURE OU LA MORT.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni utiliser
d'essence ni d'autre vapeurs ou liquides inflammables
dans le voisinage de cet appareil ou de tout autre
appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez une
odiur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir
des téléphones se trouvant dans le batiment où
vous vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur de gaz
depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service dos incendies.
L'installation et service doit être exécuté par un qualifié
installeur, agence de service ou le fournisseur de gaz.
®
SERIES
E
e l
r t c
n o
c i
M
o
e d
s l
2 -
E
D
5 4
0 4
C
N
E
2 -
E
D
5 4
0 4
C
P
E
2 -
2 -
1
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for Lennox ED4540CNM-2
Summary of Contents for Lennox ED4540CNM-2
-
Page 1: Operation Instructions
HOMEOWNER'S CARE AND OPERATION INSTRUCTIONS DIRECT VENT ® ELITE SERIES 45" DIRECT-VENT GAS FIREPLACE HEATERS P/N 504,135M REV. A 04/2001 MODELS v i l t l o r t c RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE LES INSTRUCTIONS DONNÉ... -
Page 2: Table Of Contents
GENERAL INFORMATION Note: Installation and repair should be per- In selecting this LENNOX Direct-Vent Gas Appliance you have chosen the finest and most formed by a qualified service person. The dependable fireplace to be found anywhere. A beautiful, prestigious, alternative to a appliance should be inspected annually by a wood burning fireplace. -
Page 3: Operation/Care Of Your Appliance
Carbon Monoxide Poisoning: Early signs of Once the control compartment door has been Do not use these appliances if any part has carbon monoxide poisoning are similar to removed, the modesty panel can be removed been under water. Immediately call a qualified, professional service technician to inspect the the flu with headaches, dizziness and/or nau- as follows: lift the modesty panel by the tab on... -
Page 4: Variable Flame Adjustment
CAUTION: DO NOT ATTEMPT TO TOUCH THE Inlet Pressure Port FRONT ENCLOSURE GLASS WITH YOUR Variable Flame Height Adjustment HANDS WHILE THE FIREPLACE IS IN USE. Manifold Pressure Port Maintenance The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service techni- cian. - Page 5 Maintenance Schedule Annually (Before the onset of the Burning Season) Maintenance Task Accomplishing Person Procedure Inspecting/Cleaning Burner, Logs Qualified Service Technician Inspect valve and ensure it is properly operat- and Controls ing. Check piping for leaks. Vacuum the control compartment, fireplace logs and burner area.
-
Page 6: Front Glass Enclosure Panel, Removal And Installation
Front Glass Enclosure Panel, Removal Sooting is indicated by black puffs developing Lower Compartment Door and Hinge at the tips of very long orange flames. Sooting and Installation. Top Flange results in black deposits forming on the logs, Glass Door Frame WARNING: NEVER OPERATE THE APPLI- appliance inside surfaces and on exterior sur- Glass Door... -
Page 7: Log Placement
RANTY AND WILL RESULT IN INCOM- trouble shooting guide in this manual. If problem ner while ensuring complete coverage of the PLETE COMBUSTION, SOOTING, AND persists, contact your Lennox distributor. tan sheetmetal surface. POOR FLAME QUALITY. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. -
Page 8: Wiring Diagrams
We recommend that you record the following important information about your fireplace. Please tributor, or Superior directly: contact your Lennox dealer for any questions or concerns. For the number of your nearest Lennox dealer, please call 800-731-8101 LENNOX HEARTH PRODUCTS... -
Page 9: Accessory Components
ACCESSORY COMPONENTS INDICATOR SIGNAL LIGHT LCD SCREEN MODE ON/OFF BUTTONS TIMER/ DOWN TIME COVER OPEN Screen Panel Kit 96K33 HG45 Remote Control System (Standard) 26N04 Remote Control System (Deluxe) 98K99 RC-STAT Screen Panel Kit Deluxe Remote Control System Standard Remote Control System An optional screen panel can be installed on the The Model RC-STAT (Deluxe) Remote Control The Model RC (Standard) Remote Control... - Page 10 ACCESSORY COMPONENTS (FBK-200 Models Only) Brushed Stainless Finish Hood Kit 88L51 EB45BS Brass Finish Hood Kit 96K69 EB45PB Forced Air Blower Kits -Single Speed 80L84 FBK-100 Brass Hood Kits -Variable Speed with wall-mountable switch 80L85 FBK-200 Door Frame Kits -Variable Speed with unit-mountable switch Attractive hoods are available in two styles to Brushed Stainless Finish 90L71...
-
Page 11: Lighting Instructions - Millivolt
LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo •... - Page 12 INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
-
Page 13: Lighting Instructions - Electronic
LIGHTING INSTRUCTIONS — ELECTRONIC FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions •... - Page 14 INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A.
-
Page 15: Troubleshooting Guide - Millivolt
TROUBLESHOOTING THE MILLIVOLT GAS CONTROL SYSTEM Note: Before troubleshooting the gas control system, be sure external gas shut off valve (located at gas supply inlet) is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualified service technician. POSSIBLE CAUSES SYMPTOM CORRECTIVE ACTION... -
Page 16: Troubleshooting Guide - Electronic
TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM ote: Before troubleshooting, be sure that the appliance main line gas shut-off valve, the gas control valve and the wall switch are in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualified service technician. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION... -
Page 17: Replacement Parts List
REPLACEMENT PARTS LIST . y t . y t r i F – – – – , r e , e r t e l , e l , e l , r o c i t t e l c i f e t i i t n... - Page 18 REPLACEMENT PARTS NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
- Page 19 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
- Page 20 LENNOX reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2001 by LENNOX 4325 Artesia Avenue •...
Need help?
Do you have a question about the ED4540CNM-2 and is the answer not in the manual?
Questions and answers
Pilot light and fire keep going out
The pilot light and fire on the Lennox ED4540CNM-2 may keep going out due to a defective pilot generator (thermocouple). The pilot flame must impinge on the thermocouple properly. To fix this, check the pilot flame, clean and/or adjust it for maximum contact with the thermocouple, and ensure the connection between the valve and thermocouple is tight and secure.
This answer is automatically generated