Prolonging The Life Of Your Tent/Shelter - OZtrail DTF-C300T-D Owner's Manual

Table of Contents

Advertisement

Prolonging The Life Of Your
Tent
• Temporary use only. Although our fabrics are
treated for extra UV resistance, continuous
exposure to sun light will reduce the life
of the fabric. Fading of colour is an early
warning sign. OZtrail products are not
designed as permanent dwellings or
structures.
During rain always lower awnings to avoid
water ponding.
Never store a wet and/or soiled tent/shelter;
as mildew and corrosion can form. Always
allow the tent to dry completely before
packing and stowing. If mildew occurs, use
a soft bristle brush or sponge with mild
detergent to clean it off. After beach use or
wet weather treat all zips, poles and pegs
with silicon spray.
• The elastic shock cord within the poles is
provided for easy assembly of the poles.
The shock cord is not required for any
structural reason. The poles and tent
perform perfectly well without the shock
cord. Age, over stretching and mishandling
may cause failure. Shock cord is not covered
by warranty. It's easy to replace, see the
instructions on page 12.
Sometimes the zipper coil bursts open or
does not close. This could be due to wear
or metal fatigue. The problem can be easily
fixed, see the instructions on page 15.
Always carry a roll of heavy duty tape for
simple repairs to small rips, cuts and ash
burns. This not only blocks the hole, it will
9
prevent further tearing. Heavy Duty tape is
also helpful for emergency pole repairs and
many other uses around the camp site.
• When removing pegs, do not use the
webbing or corner of the tent as your
handle. Either use another peg, a peg
remover or the claw of a hammer hooked
under the peg to remove them.
HELPFUL HINT
CONDITIONING YOUR NEW TENT
Once you get your new tent home, it is
important to condition the tent. Simply
pitch your tent and wet it down with your
garden hose until the fabric and all seams
are saturated. Pay particular attention to the
seams - the thread swells when wet and blocks
the needle holes. The needle holes also shrink
around the thread. The fabric also benefits
from this because the fibre swells into the
weave and the waterproof treatment settles
within the fabric. Let the tent dry completely
before repeating this wetting and drying
process until there is no leakage during hosing.
Always pack your tent away dry.
MATERIALS:
Frame- Steel with plastic componentry
Tent- Polyester
CARE INSTRUCTIONS:
Wipe down all surfaces with fresh water after use.
To remove marks, use a soft brush or sponge with
fresh water and mild detergent only and rinse
with fresh clean water. Allow to dry thoroughly.
Never pack away damp, dirty or wet. After beach
use or wet conditions treat all zips and metal
components with silicon spray.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fast frame cruiser 300 twin

Table of Contents