American Dynamics illustra 400 Quick Setup Manual page 6

3. Install, configure and set the IP Dome Camera
The IP Indoor Mini-dome software default setting is DHCP OFF. Users can build the IP Indoor Mini-dome
working environment with a static IP address. The default static IP is 192.168.1.168. You can set an IP
address for the IP Indoor Mini-dome if the LAN unit isn't connected to a DHCP server. Or turn on the DHCP
setting to use the DHCP protocol if the DHCP server is working in the LAN. The IP Indoor Mini-dome will
obtain an IP address automatically from the DHCP server. The IP Indoor Mini-dome is linked by its Video Out
connection via a BNC connector to a monitor's Video In connection. If this connection is enabled, you will see
information on the monitor screen, such as, the IP Indoor Mini-dome factory default Static IP address.
1. Check the IP class of your PC
Step 1: Select Settings from the Start menu, and then click Control Panel.
Step 2: Double-click the Network Connections icon. The Network Connections dialog box appears.
Step 3: Click the Protocols tab in the Network Connections dialog box.
Step 4: Select Internet Protocol (TCP/IP) and click Properties.
Step 5: Select Use the following IP Address to indicate that you do not wish to use the DHCP, and assign
IP Address 192.168.1.200 with Subnet mask 255.255.255.0. Click OK when you finish.
Step 6: Choose Close to finish the modification.
2. Install UPnP Packets of your PC
®
Microsoft Windows XP
is initialized, as described below.
Step 1: Select Set Program Access and Default from the Start menu.
Step 2: Click the Add/Remove Windows Components button when the Add or Remove Programs dialog
box appears.
Step 3: Check the Network Services in the Windows Component Wizard dialog box, and then click
Details....
Step 4: Check UPnP User Interface, and choose OK.
Step 5: Click Next when the original Network Component Wizard dialog box returns. After about one
minute the UPnP installation is complete.
Step 6: Select Finish to close.
3. Turn on Services of your PC
After installation, turn on the relative services to start the UPnP protocol. The following procedures will
demonstrate this.
Step 1: Select Settings from the Start menu, and then click Control Panel.
Step 2: Double-click the Administrative Tools icon. The Administrative Tools dialog box appears.
Step 3: Click the Services icon in the Administrative Tools dialog box.
Step 4: Double-click the SSDP Discovery Service icon when the Services dialog box shows up.
Step 5: Choose Automatic in the Startup type, and click OK to start it. The Services dialog box appears
again.
Step 6: Double-click the Universal Plug and Play Device Host icon.
Step 7: Choose Automatic in the Startup type, press the Start button, and click OK to start it.
Step 8: Restart your system.
4. Set the static IP address in the IP Dome Camera.
Step 1: Plug in the IP Dome Camera power connection.
Step 2: Plug the USB connector into your PC's USB socket and the other end of the connector in the rear of
the dome lens. A window pops up asking if you want to "Run the program", "Open folder to view files",
or "Take no action".
Step 3: Choose "Run the program" and click "OK", and the "USB configuration" window will pop up.
Step 4: Set the Network setting and type in the IP address you desire. Before you change the IP address, you
should note the factory default Static IP address ( 192.168.1.168 ).
Step 5: Click the "Apply" button in the "USB Configuration" window. A message pops up asking you to
confirm the action as "OK".
Step 6: Click "OK", and remove the USB connection from your PC.
6
does not start the UPnP service by default. Some packets must be installed before it
Quick Setup Guide