Install Unit Into Wall Sleeve - Gree GAE09AB-D3RNB1A Owner's Manual

• INSTALL UNIT INTO WALL SLEEVE

1. Carefully remove the shipping tape from the front panel and vent door. See Fig. 9.
2. Remove the shipping screw from the vent door, if present. See Fig. 10.
3. Remove the front panel. See Fig. 11.
4. Keep the unit level and slide into the wall sleeve until the foam seal rests firmly against the front of the wall sleeve.
5. Secure with four screws (supplied) through the unit flange holes. See Fig. 12.
6. Reinstall the front panel. See Fig. 13.
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Failure to remove shipping tape and screw will prevent
the fresh air vent door from opening and may result
in damage to the vent door cable.
Shipping
tape
Fig. 9 – Shipping tape location
Fig. 10 – Shipping screw location
CAUTION
Pull out at the bottom to release it from the tabs
(1). Then lift up (2).
Remove shipping
screw if present
Place tabs over top rail (1). Push inward at bottom
until panel snaps into place (2).
7
2
1
Fig. 11 – Removing front panel
Fig. 12 – Securing unit
1
2
Fig. 13 – Replacing front panel