Adjusting Rip Fence Scale Indicator; Adjusting Bevel Indicator - Hitachi C 10RJ Safety Instructions And Instruction Manual

ADJUSTING RIP FENCE SCALE INDICATOR (FIG. 32)
B
E
G
A
F
Fig. 32
C D
ADJUSTING BEVEL INDICATOR (FIG. 33)
Adjust the red line on the bevel indicator if it is not aligned with zero when the blade is perpendicular to
the table.
C
B
Fig. 33
A
• Unlock the fence rails lock lever (A).
• Set the blade at 0° bevel and move the fence (B) in until it touches
the blade.
• Lock the fence rails lock lever (A).
• Loosen the rip fence scale indicator screws (C, D) and set the red
line (E) on the rip fence scale indicator (F) to read zero.
A
• Retighten the rip fence indicator screws (C, D). The top rip scale
reads correctly only when the fence is mounted on the right side
H
of the blade and is in position 1 (G) (for 0 to 27 in. ripping) [not
the 35 in. position]. The bottom scale reads correctly only when
the fence is mounted on the right side of the blade and in position
2 (H) (for 8 in. to 35 in. ripping).
• With blade perpendicular to table, loosen screw (A).
• Set the bevel indicator (B) to align with 0° on bevel scale (C).
• Retighten screw (A).
English
43