Adjusting The Saw Prior To Use - Hitachi C 14DMR Safety Instructions And Instruction Manual

English
7. Prepare a wooden work bench (Fig. 9)
Since the saw blade will extend beyond
the lower surface of the lumber, place the
lumber on a work bench when cutting. If
a square block is utilized as a work bench,
select level ground to ensure it is prop-
erly stabilized. An unstable work bench
will result in hazardous operation.
CAUTION:
To avoid possible accident, always en-
sure that the portion of lumber remain-
ing after cutting is securely anchored or
held in position.

ADJUSTING THE SAW PRIOR TO USE

1. Adjusting the cutting depth (Fig. 10)
WARNING:
To adjust cutting depth, loosen the Wing-
nut and, while holding the base with one
hand, move the main body up and down
to obtain the prescribed cutting depth.
After adjusting to the prescribed cutting
depth, tighten the Wing-nut securely.
2. Adjusting the angle of inclination
WARNING:
22
If the wing-nut is loose,
injury can result. Tighten
it securely after adjust-
ment.
If the wing-nut is loose,
injury can result. Tighten
it securely after adjust-
ment.
Lumber
Work bench
Fig. 9
Fig. 10
Base
Saw blade
Wing-nut
Base