Table of Contents
Advertisement
Ordering guide
The following steps will guide you through configuring your E5061B.
Standard furnished item
Description
Installation guide
CD ROM IO libraries
Power cable
Certificate of calibration
Step 1. Choose test set option (Must choose one of the nine test set options.)
Option No.
50 Ω RF NA options
E5061B-115
E5061B-215
E5061B-135
E5061B-235
75 Ω RF NA options
E5061B-117
E5061B-217
E5061B-137
E5061B-237
LF-RF NA option
E5061B-3L5
Step 2. Choose impedance analysis option
(for E5061B-3L5 LF-RF network analyzer. If not required, go to step 3.)
Option No.
Software option
E5061B-005
Accessory
E5061B-720
1. Keyboard and mouse are not furnished as standard. Refer to "Step 6. accessory option" for the selection of these items.
2. This option is not applicable for the E5061B RF NA options 1x5/2x5/1x7/2x7.
3. Refer to "Software upgrade" section for retrofit information on the above option.
4. For calibration at test fixtures. Required for the gain-phase series-thru method.
1
Additional information
Contains the information necessary to start up with the E5061B.
Description
Transmission/Reflection test set, 100 kHz to 1.5 GHz, 50 Ω system impedance
S-parameter test set, 100 kHz to 1.5 GHz, 50 Ω system impedance
Transmission/Reflection test set, 100 kHz to 3 GHz, 50 Ω system impedance
S-parameter test set, 100 kHz to 3GHz, 50 Ω system impedance
Transmission/Reflection test set, 100 kHz to 1.5 GHz, 75 Ω system impedance
S-parameter test set, 100 kHz to 1.5 GHz, 75 Ω system impedance
Transmission/Reflection test set, 100 kHz to 3 GHz, 75 Ω system impedance
S-parameter test set, 100 kHz to 3GHz, 75 Ω system impedance
LF-RF network analyzer with DC bias source, 5 Hz to 3 GHz
Description
Impedance analysis for E5061B-3L5 LF-RF network analyzer
2, 3
Add 50 Ω resistor set
3, 4
2
Advertisement
Table of Contents
