Pro-Form L.E.X.2 User Manual page 6

4. Lay the Handlebar (8) on the saddle on the top of the
Upright (3). Insert a 3/8Ó Bolt (50) down through the
Handlebar, and the Upright. Thread a 3/8Ó Nylon
Locknut (29) onto the Bolt. Do not tighten the Nylon
Locknut yet.
Refer to the inset drawing. Feed the console wire
harness down into the Upright (3), until the end of the
console wire harness extends from the lower end of
the Upright. A second person will need to support
the Upright and hold the Console (6) and Console
Plate (31) until step 5 is finished.
Lay the Console Plate (31) on the Handlebar (8).
Make sure the notch in the Console Plate rests
around the 3/8Ó Bolt (50). Insert another 3/8Ó Bolt
down through the Console Plate, the Handlebar (8)
and the Upright (3). Thread a 3/8Ó Nylon Locknut (29)
onto the bolt.
Push any excess tension cable down through the
Console Plate (31) and into the Upright (3). Tighten
all parts used in this step.
5. Feed all of the slack in the console wire harness
down into the Upright (3). Attach the Console (6) to
the Console Plate (31) with four Console Screws
(77). Be careful to avoid pinching the console wire
harness.
Press the Resistance Control Knob (72) onto the
Console (6).
Press a Handlebar Cap (9) into each end of the
Handlebar (8)
6. While another person holds the Upright (3), connect
the console wire harness to the Main Wire Harness
(39). If the wire harnesses do not fit together easily,
turn themÑdo not force them together. After you
have connected the wire harnesses, pull any
slack in the wire harnesses up through the
Upright.
Slide the Upright (3) onto the welded bolts on the
Base (1). Be careful to avoid pinching the wire
harnesses. Tighten a 3/8Ó Nylon Locknut (29) onto
each welded bolt.
4
Notch
50
Tension
Cable
29
6
Console
Wire
Harness
3
5
6
Console
Wire
Harness
31
6
6
50
31
8
3
29
31
72
8
77
77
3
9