Set Up Menu; Autopilot Calibration Menu - Raymarine p70 Installation & Operation Instructions

12.1 Set up menu

The set up menu provides a range of tools and
settings to configure the pilot controller.
Menu item Description
Autopilot Pilot
Calibration commissioning /
calibration settings
User Preferences Set user
preferences such
as: Time &
Date, Units of
measurement,
Language, Vessel
type, Vessel
details, and
Variation.
System Set-up Set system
grouping, display
and system color
and brightness,
Multiple data
sources and about
system set up.
Simulator Enables or
disables simulator
mode, which
allows you to
practice operating
your instrument
display without
any data from any
other external unit.
Factory Reset Delete user
settings and
Restore unit to
factory default
settings.
Diagnostics Information About
the display and
system and key
beep on / off
setting.
Set-up Wizard Launch the initial
set-up wizard.
82

12.2 Autopilot calibration menu

The Autopilot Calibration menu options are
determined by the connected autopilot system.
Options
Note: Not all options are available when
Calibration Lock is turned On.
SeaTalk
ng
• Vessel settings.
Note:
• Drive settings.
• (1) — SPX and SeaTalk SmartPilots only.
• Sailboat
• (2) — Evolution autopilots only.
settings.
Menu
• Commissioning.
Vessel Settings
SeaTalk
• User settings.
• Dealer settings.
• Seatrial
calibration.
User preferences
menu.
Drive Settings
System set up
menu.
• On
• Off
• Yes
• No
• Yes
• No
• Language
• Vessel hull type
• Welcome page
Options
• Vessel Hull Type
• Drive Type
• Cruise Speed
(1)
• Compass Offset
• Latitude Compass Damping
• Calibration Lock
• Rudder Gain
(1)
• Response Level
(1)
• Counter Rudder
(1)
• Rudder Damping
• Auto Trim
(1)
• Auto Turn
• Power Steer
(2)
• Reverse Rudder Ref.
• Off Course Alarm
(1)
• Turn Rate Limit
(1)
• Motor Phasing
• Rudder Limit
• Rudder Offset
(2)
• Hard Over Time
p70 / p70R
(1)