Example: Initial Switch Configuration - HP OfficeConnect 1920S 8G Quick Start Quide

Connect a PC directly to the switch with a standard
Ethernet cable. Before you connect the switch to
the network, configure the IP Address and Subnet
Mask for the PC. The IP addressing allows the
switch to communicate with the switch through the
Web browser on your PC. The switch factory
default settings include the following values:
Parameter
User name
Password
IP address
Subnet Mask
Default gateway
To enable the switch to operate in your network,
modify the IP configuration as needed. See

Example: Initial Switch Configuration.

7. Connect the network cables.
NOTE:
For transceiver connections, install and use
only HPE SFP transceivers supported by the
switch. See SFP Installation Notes.
Example: Initial Switch Configuration
Procedure
1. Reconfigure the PC's IP address and Subnet Mask so that it can communicate with the switch.
a. Click Start > Control Panel. Type adapter in the search box, and then click View network
connections.
b. Select and right-click Local Area Connection, then click Properties.
c. Click the Networking tab. Select Internet Protocol Version 4 (TCP/IPv4) under This connection
uses the following items, and then click Properties.
NOTE:
Be sure to record all your PC's current IP settings to be able to restore them later.
d. On the General tab, click Use the following IP address.
e. For IP address, enter an IP address in the same range as the switch's default IP address. For
example, enter 192.168.1.12.
Factory Default Setting
admin
<blank>
192.168.1.1
255.255.255.0
not set
Example: Initial Switch Configuration 7