Table of Contents
Advertisement
4.6
CO Line Programming
ISDN Outgoing CLIR Service Assignment
Description
Selection
Default
Programming
Conditions
Feature References
Assigns whether ISDN CLIR (Calling Line Identification
Restriction) service is enabled or disabled for outgoing outside
calls. If disabled, the subscriber's number of your system is
informed to the called party.
•
CO line number:
KX-TD816 – 01 through 08,
(
KX-TD1232 – 01 through 24,
(
• Enable / Disable
All CO lines – Enable
1.
Enter 419.
Display: ISDN CLIR Send
2.
Press NEXT.
Display: CO Line NO?→
3.
Enter a CO line number.
To enter CO line number 05 for KX-TD816 or 09 for KX-TD1232,
you can also press NEXT.
Display example: CO09:Enable
4.
Keep pressing SELECT until the desired selection is
displayed.
5.
Press STORE.
6.
To program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
7.
Repeat steps 4 through 6.
8.
Press END.
• In the case of KX-TD1232, CO01 through CO12 are for the Master
System and CO13 through CO24 are for the Slave, if available.
• To assign all CO lines to one selection, press the
this case, the display shows the contents programmed for CO05 (for
KX-TD816) or CO09 (for KX-TD1232).
• Program [418] "ISDN Line Number Assignment" is used to store the
subscriber's number of your system that is informed to the called party.
Section 3, Features,
Calling Line Identification Restriction (CLIR) — in this manual
CO Incoming Call Information Display — in this manual
=all CO lines)
=all CO lines)
419
key in step 3. In
35
Advertisement
Table of Contents
