What's Included - Ikelite 5516.69 Instruction Manual

WHAT'S INCLUDED

- Lens extension
- Securing screws
- Silicone lubricant 1cc tube
INSTALLING THE LENS EXTENSION and PORT
1. First, check to see that there is a thin film of lubricant on the Port Base
and Lens Extension o-rings. The o-ring should appear slick. If necessary,
relubricate with the supplied Ikelite lubricant. Do not use excessive lubricant
which can attract hair or other debris. Use ONLY Ikelite lubricant.
2. Make sure the Port Base and Lens Extension o-rings are free of hair or
other debris.
3. Lift and REMOVE the gear sleeve from inside the Port Base if applicable.
The gear sleeve must be removed BEFORE using the Lens Extension.
Place the Gear Sleeve in storage for later use.
4. Slide the Lens Extension over the Port Base until it STOPS, Diagram A,
page 3. When properly installed, there should be an approximate 5/32" or
less gap between the bottom of the Lens Extension and the front of the
housing, Diagram B, page 4.
5. Snugly tighten the three Securing Screws into the Port Base. DO NOT
overtighten. No Securing Screw threads will be visible once the Lens
Extension is properly secured.
6. Slide the Port over the Lens Extension and tighten the three Securing
Screws in the Port. When properly installed, the bottom of the Port will
contact the top Ledge of the Lens Extension below the Lens Extension
o-ring, Diagrams C and D, page 5.
7. Snugly tighten the Three Securing Screws into the Lens Extension. DO
NOT overtighten. No Securing Screw threads will be visible once the Lens
Extension is properly secured.
2