Step 6. Move The Refrigerator - Monogram ZWE23E series Installation Instructions Manual

Double-door, bottom-drawer free-standing refrigerator
Hide thumbs Also See for ZWE23E series:
Table of Contents

Advertisement

Available languages

Available languages

STEP 5 REMOVE THE FRESH
FOOD DOORS (CONT)
D. Disconnect the water line from the back of the unit
by pressing down on the dark grey collar while
pulling up on the water line.
Pull waterline through case conduit from the top to
free the line for door removal. The water line is more
than 4' long and may need to be taped to Door for
accessibility when reinstalling.
E. Using a 3/8" socket ratchet/
driver, remove the screws
securing the top hinge to the
cabinet, then lift the hinge
straight up to free the hinge pin
from the location in the top of
the door.
CAUTION
Lifting Hazard.
Single person lift could cause injury. Use assis-
tance when handling, moving or lifting the refrig-
erator doors.
ATTENTION
Avertissement de porte
lourde.
Le soulèvement de la porte par une seule personne
peut présenter un risque de blessure. Obtenir de l'as-
sistance lors de la manipulation, du déplacement ou du
soulèvement des portes du réfrigérateur.
PRECAUCIÓN
Riesgo al levantar la puerta
Si es levantada por una sola persona, podrían ocasio-
narse lesiones. Solicite ayuda al sostener, mover o
levantar las puertas del refrigerador.
Note: when removing door, to prevent damage to
door and electronics, carefully place the door in a
proper location.
Note: The lower door hinge pin and hinge are keyed
and must be matched correctly for the door to self
close properly. Please follow the directions carefully.
Installation Instructions
STEP 5 REMOVE THE FRESH
FOOD DOORS (CONT)
Note: for proper installation later, please follow
the next step carefully.
F. Fresh Food doors to be REMOVED and
INSTALLED opened at 90° with case front.
REMOVE OPPOSITE DOOR
Follow the same procedure on the opposite door.
There are no wires or water lines on the opposite
side.
G. REMOVE CENTER HINGE (if necessary)
cabinet. Use T20 driver to remove outboard screw.
Remove
center screw
STEP 6
MOVE THE REFRIGERATOR
• Place a piece of the carton or soft cloth against the
side panel of the refrigerator to pad and protect the
stainless steel finish.
• Place the refrigerator on the handtruck with a side
against the truck only.
• Move the refrigerator indoors. Place refrigerator
close to the installation location.
10
Loosen Outer screws

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zwe23p seriesZwe23eZwe23p

Table of Contents