Step 2. Install Anti-Tip Bracket - Monogram ZWE23E series Installation Instructions Manual

Double-door, bottom-drawer free-standing refrigerator
Hide thumbs Also See for ZWE23E series:
Table of Contents

Advertisement

Available languages

Available languages

STEP 2A LOCATE ANTI-TIP FLOOR
BRACKET (CONT.)
Figure 2 – Acceptable Screw
Placement Locations
Preferred Installation –
Wood
Minimum Acceptable #1 –
Wall Plate Stud
Minimum Acceptable #3 –
Concrete Floor
STEP 2B INSTALL ANTI-TIP
BRACKET
WOOD Wall and Floor Construction:
A. Drill the appropriate number of 1/8" pilot holes in the
center of each floor bracket hole being used (a nail
or awl may be used if a drill is not available) AND
remove the locator template from the floor.
B. Mount the anti-tip floor bracket by fastening the 2,
or preferably 4, #10-16 hex-head screws tightly into
place as illustrated in Figure 3.
Figure 3 – Attachment to
Wall and Floor
Rear RH Corner
of the Refrigerator
Floor
Installation Instructions
Preferred Installation –
Concrete
Minimum Acceptable #2 –
Wood Floor
Wall
Floor Bracket
2 Screws Must
Wall
Enter Wood
Plate
or Metal Stud
Stud
STEP 2B INSTALL ANTI-TIP
BRACKET (CONT.)
CONCRETE Wall and Floor Construction:
A. Anchors required (not provided):
4 each 1/4" x 1 1/2" lag bolts
4 each 1/2" O.D. sleeve anchors
B. Drill the recommended size holes for the anchors
into the concrete at the center of the holes marked
in Step 2.
C. Install the sleeve anchors into the drilled holes.
Place the anti-tip floor bracket as indicated in Step
2. Remove the locator template from the floor.
D. Install the lag bolts through the anti-tip floor bracket
and tighten appropriately.
WOOD Wall and TILE Floor Construction:
A. For this special case, locate the 2 wall holes
identified in Fig. 2. Drill an angled 1/8" pilot hole
(approx. as shown in Fig. 3) in the center of each
hole.
B. Mount the anti-tip floor bracket using the Minimum
Acceptable Installation #1, as illustrated in Fig. 2.
STEP 2C POSITION THE
REFRIGERATOR TO
ENGAGE THE ANTI-
TIP FLOOR AND BASE
BRACKETS
A. Before pushing the refrigerator into the opening,
plug the power cord into the receptacle and connect
waterline (if equipped). Check for leaks.
B. Locate the refrigerator's RH side and move back
approximately in line with the RH side of the cabinet
opening, W. This should position the anti-tip floor
bracket to engage the anti-tip base bracket on the
refrigerator.
C. Gently roll the refrigerator back into the cabinet
opening until it comes to a complete stop. Check to
see if the refrigerator front lines up with the cabinet
front face. If not, carefully rock the refrigerator
forward and backward until engagement occurs and
you notice thatthe refrigerator is fully pushed up
against the rear wall.
D. OPTIONAL: Adjust the rear (and front) wheel height
settings to fully engage the rear anti-tip brackets,
while also aligning the refrigerator front with the
cabinet front face.
NOTE: If you pull the refrigerator out and away from
the wall for any reason, make sure the anti-tip floor
bracket is engaged when the refrigerator is pushed
back against the wall rear wall.
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zwe23p seriesZwe23eZwe23p

Table of Contents