Steering Cylinder - Toro Multi Pro 5800 Service Manual

Steering Cylinder

1. Front axle
o
2. 90 hydraulic fitting (2)
3. Steering cylinder
4. Jam nut
5. Grease fitting
Removal (Fig. 59)
1. Park the machine on a level surface, engage the
parking brake and stop the engine. Remove the key
from the ignition switch.
CAUTION
Rotate steering wheel and depress traction ped-
al in both forward and reverse to relieve hydrau-
lic system pressure and to avoid injury from
pressurized hydraulic oil.
Hydraulic System
1
12
13
20 to 25 ft−lb
14
(27 to 34 N−m)
Figure 59
6. Ball joint
7. Rod end seal
8. Front axle spindle
9. Thrust washer
10. Slotted hex nut
Page 5 − 82
2
3
2
9
10
20 to 25 ft−lb
11
(27 to 34 N−m)
2. Operate all hydraulic controls to relieve hydraulic
system pressure.
3. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
4. Label hydraulic hoses for assembly purposes. Thor-
oughly clean hydraulic hose ends and fittings prior to
disconnecting the hoses from steering cylinder.
5. Disconnect hydraulic hoses from steering cylinder
(Fig. 60). Allow hoses to drain into a suitable container.
RIGHT
FRONT
4
5
6
7
8
11. Cotter pin
12. Thrust washer
13. Lock nut
14. Cotter pin
Multi Pro 5800