Caution For Safety - Samsung SCX-4216F Service Manual

Precautions

1.2 Caution for safety

1.2.1 Precaution related noxious material
It is possible to get harmed from noxious material if you ignore the below information.
(1) Do not touch the damaged LCD. This PRINTER has LCD in control panel. Noxious liquid to human body exists in the
LCD. If it is got into mouth, immediately see a doctor. If it is got into eyes or on skin, immediately wash off over 15
minutes with flowing water and see a doctor.
(2) The toner in a printer cartridge contains a chemical material, which might harm human body if it is swallowed.
Please keep children out of the toner cartridge.
1.2.2 Precaution related electric shock or fire
It is possible to get electric shock or burn by fire if you don't follow the instructions of the manual.
(1) Use exact voltage. Please do use an exact voltage and wall socket. If not, a fire or an electric leakage
can be caused.
(2) Use authorized power code. Do use the power code supplied with PRINTER. A fire can be occurred
when over current flows in the power code.
(3) Do not insert many cords into a outlet. If do, a fire can occur due to a over flow of current in an outlet.
(4) Do not put water or extraneous matter in the PRINTER. Please do not put water, other liquid, pin, clip,
etc. It can cause a fire, electric shock, or malfunction. If it happens, turn off the power and remove the
power plug from outlet immediately.
(5) Do not touch the power plug with a wet hand. When servicing, remove the power plug from the outlet
and do not insert or remove it with a wet hand. Electric shock can occur.
(6) Use caution when inserting or taking off the power plug. The power plug has to be inserted completely.
If not, a fire will be caused due to poor contact. When taking off the power plug, grip the plug and
remove it.
(7) Management of power cord. Do not bend, twist, bind or place other materials on it. Do not use stales
around printer. If the power code gets damage, a fire or electric shock can occur. A damaged power
code must be replaced immediately. Do not repair the damaged part or reuse it. Repairing cord with
plastic tape can cause a fire or electric shock. Do not spread chemicals on the power code. Do not
spread insecticide on the power code. A fire or electric shock can occurred due to a thin(weak) cover on
the power code.
(8) Check whether the power outlet and the power plug are damaged, pressed or chopped. When such
inferiorities are found, repair it immediately. Do not press or chop the cord when moving the machine.
(9) Use caution during thunder or lightning storms. It may cause fire or electric shock. Take the power plug
off under these conditions. Do not touch cable and device duing thender or lightening storms.
(10) Avoid damp or dusty areas. Do not install the printer in dusty areas or around humidifiers. A fire can
occurr. Clean plug well with dried fabric to remove dust. Fire can occur if water is dropped into the unit
or if coverd with dust.
(11) Avoid direct sunlight. Do not install the printer near to a window where it directly contacts to the sun-
light. If the machine contacts sunlight for a long time, the machine will not work properly, because the
inner temperature of machine will get higher. A fire can beoccur.
(12) Turn off the power and take off the plug when smoke, a strange smell, or sound from the machine is
detected. A fire can occur if unit is used under these conditions.
(13) Do not insert steel or metal pieces inside/outside of the machine. Do not put steel or metal piece into
the ventila-tor. An electric shock can occur.
Service Manual
1-2
Samsung Electronics