Sony MVS-6500 System Startup Manual page 14

1
Connect devices to the PRIMARY INPUTS of the
switcher processor.
a Connect the cameras for recording.
In this example, connect four cameras to
PRIMARY INPUTS 1 to 4.
b Connect the playback VTRs.
In this example, connect two VTRs to PRIMARY
INPUTS 5 and 6.
c Connect the character generator.
In this example, connect to PRIMARY INPUTS 7
and 8.
2
Connect devices to the OUTPUTS of the switcher
processor.
a Connect the video monitors.
In this example, connect two monitors to
OUTPUTS 1 and 2.
b Connect the monitor for multi viewer.
In this example, connect to OUTPUTS 9.
3
Connect reference signals to the REF INPUT
connectors of the switcher processor.
a Connect one REF INPUT connector to a reference
signal generator.
b Terminate the other REF INPUT connector using
the supplied 75 ohm terminator.
To use the tally
Set the tally output, using either the SERIAL TALLY
connector or the TALLY connector (parallel tally) of the
switcher processor
TALLY connector (GPI IN/OUT connector)
SERIAL TALLY connector
To use an external monitor for menu
operations
Instead of the dedicated MVS system ICP-6511 menu
panel, you can connect an external monitor and operate the
menus from a touch panel or by mouse control.
14
Connecting Devices
External monitor connection
DVI-D connector
DEVICE connector
Connect the DVI-D connector of the control panel and the
DVI-D connector of the external monitor using a DVI
cable.
If using a touch panel, connect the DEVICE connector of
the control panel and the USB connector of the external
monitor using a USB cable.
If using a mouse, connect the mouse to the DEVICE
connector of the control panel using a USB cable.
For details about connecting monitors, contact your Sony
representative.