Standard Or Angle Mounting Instructions; Yoke Cover; Downrod - Honeywell 50206 Manual

STANDARD OR ANGLE MOUNTING INSTRUCTIONS

6. Partially loosen the set screws in the yoke at the
top of the motor housing (Fig. 6).
7. Remove the downrod pin and downrod clip from
the downrod (Fig. 7).
Downrod Pin
Downrod Clip
8. Thread the wires from the motor housing through
the yoke cover, canopy, and out the top of the
downrod (Fig. 8).
Fig. 6
Fig. 7
Fig. 8
7
Set Screws

Downrod

Clip
Downrod
Pin
Downrod
Canopy
Yoke
Cover
Housing
Motor