Depression On The Leading Edge Is Left; The Size Of Clear Film Cannot Be Detected; Roll Paper Is Continuously Ejected - Canon iPF670 User Manual

Depression on the leading edge is left

In the Control Panel menu, Cutting Mode is set to Eject or Man-
ual.
Depression on the leading edge is left
Depression on the leading edge is left
Keeping a roll in the printer for a long time
without printing on it may leave a depression
on the leading edge.

The size of clear film cannot be detected

The size of clear film cannot be detected
The Platen is soiled with ink or other substances.

Roll Paper is Continuously Ejected

Roll Paper is Continuously Ejected
Cause
Although sheets are se-
lected as the paper
source, a roll was ad-
vanced.
586
Cause
Cause
When printing quality is most important, we recommend setting TrimEdge Reload to On
or Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.")
Cause
After roll ejection stops, follow these steps to reload the roll.
1.
Push the Release Lever back.
2.
Open the Roll Cover.
3.
Using both hands, rotate the Roll Holder toward the back to rewind the roll. At this time, ensure that both
ends of the roll are rewound evenly.
4.
Pull the Release Lever forward.
5.
Load the roll. At this time, be sure to press the Load button and select "Load Roll Paper".
(See "Loading Rolls in the Printer.")
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
(See "Specifying the Cutting Method for Rolls.")
P.452
➔
Corrective Action
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
Corrective Action
P.357
➔
Corrective Action
Corrective Action
P.563
➔
iPF670
P.369
➔
User's Guide