Brother P-touch QL-710W Service Manual page 99

Operation procedure for each inspection is explained below.
Implement "Read serial no" first in the inspection list. The next available inspection
becomes operable after completion of the inspection. All the listed inspections will be
completed by operating in descending order.
"Write serial no" is the last item to be operable. Always operate the all inspections
through the last inspection item.
Inspection list
Inspection names
Read serial no
Check MAC address (*1)
Write add media information
Write default eeprom data (*2)
Sensor white level check
Sensor black level check
Temperature and WiFi button check
Media and cover sensors check
Cut test
Adjustment print test(Continuous)
Adjustment print test(Diecut) (*2)
Start WiFi module
Check WiFi MAC address (*3)
Stop WiFi module (*4)
Write serial no
*1 Not performed for the QL-710W. Must be performed for the QL-720NW.
*2 Invalid for both the QL-710W and QL-720NW.
*3 Becomes valid when "Start WiFi module" is performed.
*4 Becomes valid when "Check WiFi MAC address" is performed.
Precautions for using Serviceman Software Tool QL-720NW and details of each
inspection will follow from the next page.
Communication
I/F
USB
These inspections must be
USB
performed in this order.
USB
USB
USB
USB
USB
USB
These inspections may be
USB
performed in any order.
USB
USB
USB
USB
USB
USB
Be sure to perform this inspection last.
1 - 10