Philips 19HFL3007D/10 Service Manual page 13

4.3.2 Rear Cover
Refer to Figure 4-5 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1
4.3.3 Small Signal Board (SSB)
Refer to Figure 4-6 for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS/Flat Foil connector that
connect with the SSB [1].
Caution: be careful, as these are very fragile connectors!
Take the flat foils out of their connectors.
2. Release the clamps and unplug all other connectors [2].
3. Remove all the fixation screws from the SSB [3].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-6 for details.
Mechanical Instructions
1. Remove the fixation screws [1,2] that secure the rear
2. Lift the rear cover from the TV. Make sure that wires and
2
Figure 4-5 Rear cover removal
back to
div. table
TPM9.3HE LA
cover.
flat foils are not damaged while lifting the rear cover from
the set.
1
1
3
2
3
Figure 4-6 SSB removal
4. EN 13
3 × 8
1
4 × 14
2
1
19380_103_120903.eps
120924
3
1
3
19380_104_120903.eps
120903
2012-Sep-28