Samsung VP-D371 Service Manual page 43

4-2-9 Motor Loading, Gear Tension, Gear Cam Main
4-2-9(a) Disassembly
1) Eliminate pt welding 2 part Œ.
2) Remove the 1 Screw ´ and the 1 Hook ˇ, and then
lift up the Motor Loading Ass'y ¨.
3) Remove the 2 Screws ˆ, and then lift up the Guide
Tension Ø, Gear Cam Main ∏.
2 SCREWS ˆ
GEAR CAM MAIN ∏
Samsung Electronics
1 SCREW ´
Fig. 4-14 Motor Loading, Gear Tension, Gear Cam Main
4-2-9(b) Reassembly
1) After assemble and fit Gear Tension Ø, Gear Cam
Main ∏ to assemble point, and then secure the
2 Screws ˆ.
2) Insert Hook of Motor Loading Ass'y ¨ to assemble
point of Main Chassis, and then secure the 1 Screw
´.
3) After assemble FPC to Motor, and then weld pt
welding 2 parts Œ.
Note 1 : When reassembling, confirm that pin of Slide
Main insert into Cam of Gear Cam Main.
ASSEMBLE POINT
(TWO ARROWS)
Ø GEAR TENSION
¨ MOTOR LOADING ASS'Y
ˇ 1 HOOK
Disassembly and Reassembly
ΠPT WELDING 2 POINTS
4-15