[Convergence Adjustment]; [Static Convergence Adjustment] - Sony BVM-D14H1E Maintenance Manual

[Convergence Adjustment]

. . . . . Preparation
1. Connect the 480/60p cross-hatch signal to the ANA-
LOG Y/G input connector.
2. Press the SHIFT button to ON. [The LED (orange) on
top of the button turns on.]
3. Press the 16:9 OFF button [to turn off the LED
(orange)] to select the 4:3 mode.
4. Press the SHIFT button to set the SHIFT OFF. [The
LED (orange) on top of the button turns off.]
5. Press the UNDER SCAN button (
position to select the NORMAL mode of adjustment.
[The green LED turns off.]
Fig. 1-12
3-10
) to its OFF
Purity
6-pole
4-pole

[Static Convergence Adjustment]

. . . . . Horizontal Static Convergence Adjustment
1. Adjust RV701 (H. STAT) on the C board so that the
red dots and the green dots are correctly converged.
2. When the blue dot is mis-converged with respect to the
red and green dots, implement the HMC (horizontal
misconvergence) correction by adjusting the 4-pole
magnet and the 6-pole magnet of the DY.
. . . . . Vertical Static Convergence Adjustment
1. Implement the VMC (vertical misconvergence)
correction by adjusting the 4-pole magnet and the 6-
pole magnet of the DY.
R
G
B
Fig. 1-13
Fig. 1-14
BVM-D14H1U/D14H5U/D14H1E/D14H5E/D14H1A/D14H5A
R G B