Sony BVM-D14H1E Maintenance Manual page 30

F
Displaying Information About the Monitor
— STATUS Menu
Overview
The STATUS menu is used to view general data about
the monitor and information about signals assigned to
the slots in the rear panel.
The following information is displayed on the two
pages of the STATUS menu.
Structure of the STATUS Menu
Level 1 Level 2
STATUS (1/2) F1
STATUS (2/2) F2
SLOT 1 F3 MODEL NAME
SERIAL NO
Setting Lists of the STATUS Menu
This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 26(E).
• The arrow mark (÷) refers you to another setting
list that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not
have any sub-list.
[F] STATUS menu
Select the STATUS menu 1/2 or 2/2. ÷[F1]
[F1] STATUS (1/2) menu
Data about the current channel is displayed.
CH: channel number
SL: slot number
IN: input connector number
FORMAT: format of the input signal
NAME: channel name
42
(E)
• Data about the current channel (STATUS menu
(1/2))
• Data about the monitor in use and data about the
input adaptors installed into the slots on the rear
panel (STATUS menu (2/2))
[F2] STATUS (2/2) menu
Data about the monitor is displayed at the upper half of
the display.
MODEL NAME: model name
SERIAL NO: serial number
OPERATION TIME: operation time (in hours)
SOFTWARE VERSION: software version
Data about the input adaptors installed into the
respective slots in the rear panel is displayed at the
lower half of the display.
When the BKM-129X is installed in SLOT 1, the
following is displayed. When any optional boards are
not installed, EMPTY is displayed for SLOT 2 and
SLOT 3.
SLOT1: COMPONENT ÷[F3]
SLOT2: EMPTY ÷[F3]
SLOT3: EMPTY ÷[F3]
[F3] SLOT 1 to 3 menu
Select the desired slot. Data about the optional board
installed in the selected slot is displayed.
MODEL NAME: Model name of that optional board
SERIAL NO: Serial number of that circuit board
G
Adjusting the Position, Size and Geometry of
the Picture — ALIGNMENT Menu
Overview
The ALIGNMENT menu is used for adjusting the
position, size and geometry of the picture.
Structure of the ALIGNMENT Menu
Level 1
V SIZE
V CENTER
H SIZE
H PHASE
H PIN
H KEY
Setting Lists of the ALIGNMENT Menu
This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see "About
menu numbers" on page 26(E).
43
(E)